橡胶技术网

合成橡胶工业
CHINA SYNTHETIC RUBBER INDUSTRY
2009 Vol.32 No.6 P.503-506

 橡胶技术网

天然橡胶/硫黄/N-叔丁基-2-苯并噻唑次磺酰胺体系硫化反应动力学参数的拟合

赵菲　 李峰　 张萍　

摘　要：以N-叔丁基-2-苯并噻唑次磺酰胺为促进剂,通过橡胶加工分析仪测试了天然橡胶硫黄硫化体系的硫化曲线,用硫化反应动力学模型和Origin 6.0软件对诱导期后的硫化曲线进行非线性拟合,计算了该模型的有关动力学参数,探讨了硫黄用量和硫化温度对参数的影响.结果表明,在实验范围内,拟合的硫化曲线与实际的硫化曲线相吻合;在相同硫化温度下,硫化先驱体形成交联键的反应活性随着硫链长度的增加有所下降,而交联键长度的增加使其降解的速率常数也增大;随着硫黄用量的增加,硫化活性中间体形成交联键的趋势下降,生成副产物的几率增加,总的硫黄利用率下降;在相同硫黄用量下,交联键的分解反应对温度的依赖性比硫化先驱体分解产生交联中间体的反应更强.
关键词：天然橡胶;硫黄;N-叔丁基-2-苯并噻唑次磺酰胺;硫化反应动力学;非线性拟合
分类号：TQ332.1~+4 　文献标识码：B
文章编号：1000-1255(2009)06-0503-04

Fitting of cure reaction kinetics parameters based on natural rubber/sulfur/N-tert-butyl-benzothiazole-2-sulfenamide

Zhao Fei（Key Laboratory of Rubber-Plastics of Ministry of Education,Qingdao University of Science and Technology, Qingdao 266042, China）　 Li Feng（Key Laboratory of Rubber-Plastics of Ministry of Education,Qingdao University of Science and Technology, Qingdao 266042, China）　 Zhang Ping（Key Laboratory of Rubber-Plastics of Ministry of Education,Qingdao University of Science and Technology, Qingdao 266042, China）　

Abstract：The cure curves of natural rubber were tested by rubber processing analyzer with sulfur as curing agent, and N-tert-butyl-benzothiazole-2-sulfenamide as accelerator.The cure curves of curing and overcure periods were then non-linear fitted by a cure reaction kinetics model and Origin 6.0 software and the kinetic parameters were calculated.Effect of sulfur dosage and cure temperature on the parameters was explored.The results showed that the simulated curves fitted well with the experimental curves.Rate constant for formation of activated crosslinking precursors decreased with increasing sulfur chain, while rate constant for crosslink degradation increased with extending crosslinkage under the same cure temperature.The tendency for formation of crosslinkage from activated intermediate decreased with the increasing sulfur dosage, the probability of generating by-product increased,and the sulfur efficiency decreased.The crosslinkage decomposition reaction had a stronger dependence of cure temperature than that of precursor decomposited to intermediate.
Keywords：natural rubber; sulfur; N-tert-butyl-benzothiazole-2-sulfenamide; cure reaction kinetics; non-linear fitting

基金项目：国家自然科学基金资助项目(20674043);青岛科技大学引进人才科研启动基金资助项目.
作者简介：赵菲(1968-),女,副教授.已发表论文20余篇.
作者单位：赵菲（青岛科技大学,橡塑材料与工程教育部重点实验室,山东,青岛,266042）　
　　　　　李峰（青岛科技大学,橡塑材料与工程教育部重点实验室,山东,青岛,266042）　
　　　　　张萍（青岛科技大学,橡塑材料与工程教育部重点实验室,山东,青岛,266042）　

参考文献：

[1]Scheele W.Kinetic studies of the vulcanization of natural and synthetic rubber[J].Rubb Chem Technol,1961,34(5):1306-1401.
[2]Coran A Y.Vulcanization (Ⅵ):A model and treatment for scorch delay kinetics[J].Rubb Chem Technol,1964,37(3):689-697.
[3]Russel R.Kinetics of thiazole-accelerated sulfur vulcanization of natural rubber[J].Rubb Chem Technol,1963,36(4):835-843.
[4]黄宝琛,范汝良,张勇,等.NR硫化返原过程的动力学研究[J].合成橡胶工业,2000,47(4):195-200.
[5]Ding R,Leonov A I.A kinetic model for sulfur accelerated vulcanization of a natural rubber compound[J].Polymer Science,1996,61(1):455-463.
[6]Morrison N J,Porter M.Temperature effects on the stability of intermediates and crosslinks in sulfur vulcanization[J].Rubb Chem Technol,1984,57(1):63-65.
[7]戈明亮,阚长华,易玉华.橡胶硫化反应动力学研究概况[J].橡胶工业,2004,54(10):631-635.
[8]李咏今.橡胶硫化曲线变化的数学模型拟合(Ⅰ):有返原现象的硫化曲线[J].合成橡胶工业,1995,18(1):29-31.
[9]龚蓬,张祥福,张隐西.NR硫化返原动力学研究[J].合成橡胶工业,1997,44(4):195-200.
[10]Ding R,Leonov A I,Coran A Y.A study of the vulcanization kinetics of an accelerated sulfur SBR compound[J].Rubber Chem Technol,1996,69(1):81-91.
[11]Redding R B,Smith D A.Rapid measurement of the chemical contribution to network chain density for natural rubber[J].Polymer Science,1970,30:491-502.
[12]蔡超,高作宁.Microcal Origin软件包在数据处理与图形绘制中的应用[J].宁夏工程技术,2003,2(1):81-83.
[13]金哲,金林虎.Origin 6.1 在实验数据处理和分析中的应用[J].延边大学学报:自然科学版,2002,28(4):271-273.
[14]陈旭红.用Origin软件的线性拟合和非线性曲线拟合功能处理实验数据[J].江苏技术师范学院学报,2006,12(6):85-88.

收稿日期：2008年10月22日

修稿日期：2009年8月20日

出版日期：2009年11月15日